Using The Handle Button - WAGNER POWER ROLLER MAX Manual Del Propietário

Use the chart below as a guide when following the painting and priming instructions below.
When you are. . .
• Starting up
• Using 9" roller arm
• Cleaning up
• Using 3" x 3" trim pad
• Using 2" x 4" corner pad
Priming:
1a. If using the roller, set the variable speed dial to 9.
2. To start the motor, fully press and release the handle
button.
Painting (2 methods):
1) Stop and Start
The Stop and Start method is recommended when you are
using the trim pad, or the corner pad, or swivel stain pad.
Select desired speed. Partially depress the handle button
until material appears through the roller or pad. Material
will continue to flow while button is held in this position.
Release button to stop flow of material.
2) Continuous Flow
The continuous flow method is recommended when you are
painting a large area with the roller.
Select desired speed. Fully press and release handle button.
To stop flow of paint, fully press and release handle button
once again.
English
All manuals and user guides at all-guides.com

Using the Handle Button

Do this. . .
1) Set speed dial on higher speed (3-9).
2) Fully press and release handle button to start motor.
3) Press handle button again stop.
1) Set speed dial to slower speed (1-2).
2) Partially depress and release button. Release the
button when you have the desired amount of paint.
9
and the unit will. . .
Unit will stay running when the button is
fully pressed and released. Unit will stop
when the button is again pressed and
released.
Unit will run when the button is partially
depressed, and stop when the button is
released.
1b. If using one of the pads, set the variable speed dial to a
lower setting (1-2).
1 - 2
3a) If using the roller:
When paint appears through
the roller, PRESS and
RELEASE handle button to
shut off the motor and stop
the flow of paint.
6
3b) If using one of the
pads:
PRESS and RELEASE the
handle button when the
material reaches the bottom
of the handle.