Cleanup - Flushing The Unit; Before You Begin Cleaning - WAGNER RENUVO Manual De Usario

Before you begin cleaning

When cleaning the Renuvo, make sure to use the appropriate
cleaning solution for the type of material used.
• If you used latex-based materials, use warm, soapy water
to clean the Renuvo.
• If you used oil-based materials, use mineral spirits.
You will need
• A large bucket or other container that will hold cleaning
solution.
• Petroleum jelly
Tip: A large laundry tub filled with warm, soapy water is
ideal for cleanup if you used latex-based materials.
To Flush the Unit
1. Press the red quick-release tabs (b) on the unit and
remove the container. Remove the cap and pour out any
remaining material.
2. Fill the container with the appropriate cleaning solution
(warm, soapy water for latex-based materials; mineral
spirits for oil-based materials). Reattach the container.
3. While holding the Renuvo over an empty bucket, hold
the trigger and gently shake the unit up and down. This
slight agitation will help break up any material particles left
inside the connecting areas of the unit. Do this until the
container is empty.
4. Remove the pad and brush assembly. If you used the
brushes, remove them from the pad. Clean the pad
and brushes and rinse the container by hand using the
appropriate cleaning solution.
5. Remove the container. Be sure to remove any coating
material that may be present around the valve area of the
container (see inset).
6. Apply a thin layer of petroleum jelly to the O-rings on the
container valve.
Move on to "Cleaning the container parts", next page.
4
© Wagner Spray Tech. - All Rights Reserved
Cleanup -
5
Flushing the unit
1
2
OR
MINERAL
SPIRITS
3
b
b
6
English
5