brennenstuhl BS 5000 MA Manual De Instrucciones página 9

BS 5000 MA
The floodlight can also be operated without battery cover up to the 12 Ah battery.
In this case, however, the protection type is reduced to IP20 and the floodlight may only
be operated in a dry environment. To do so, open the battery cover locking (fig. 2a).
Afterwards, open the battery cover (fig. 2b), to then remove the fixing screw as described
in fig. 2c. In order not to lose the fixing screw, fix it at the floodlight again (fig. 2d).
2a
2c
COMMISSIONING
Place the floodlight on a dry and level surface.
The adjustable bracket can be used to set various inclinations for the floodlight.
To switch the floodlight on, operate the button on the back (fig. 3a).
Press the button multiple times (fig. 3a), to set the brightness to 100%, then 50% and then "off".
Keep the button pressed (fig. 3b), to continuously reduce or increase the brightness.
The lower the brightness selected, the longer the floodlight will burn.
If the switch is left in any of its "on" positions for longer than 5 seconds, then pressing it
once again will always turn it off.
If the battery is almost flat, the LED floodlight will flash 5 times. Afterwards, the floodlight
remains on for approx. 10 minutes - depending on the battery capacity - with 100%
brightness before it is switched off by the deep discharge protection function.
This ensures sufficient time to change the battery or complete work.
004721 BA_BS 5000 MA 0533052.indd 9 004721 BA_BS 5000 MA 0533052.indd 9
2b
2d
>8 Ah
Operating instructions
9
21.12.21 14:19 21.12.21 14:19