Imetec P8403 Instrucciones De Uso página 22

After a light or acoustic signal on the product itself, indicating that the filter needs to be replaced, proceed
as follows:
• Open the package and take the protective red pads out of the anti-scale filter;
• Insert the anti-scale filter in its seat, pressing it fully down;
• Close the filter cover;
• Reset the product as follows: press the button on the right-hand side of the control panel (reset or set
or *) for at least 3 seconds, until you hear a beep and the indicator light turns off;
You can now continue the ironing tasks.
*note: imetec zerocalc model - reset button, imetec intellivapor model - set button, imetec onda models
- button
NOTE: When using the iron for the first time or whenever the filter is replaced, on pressing
the steam request button (13), a slight buzz will be heard and the iron will not generate
steam.
This is absolutely normal and is caused by the anti-scale filter filling up. Keep the steam
request button (13) pressed for at least 1 minute, until the buzzing stops and the iron begins
to deliver steam.
NOTE: the electronic system modifies steam emission to safeguard the lifespan of the
product. The anti-scale filter (14) must be replaced as soon as possible.
Failure to replace the anti-scale filter (14) will invalidate the warranty.
CLEANING
WARNING! Make sure the plug is disconnected from the
socket and the plate has cooled down completely before
cleaning the iron.
EN
19