Bosch RH328VC Instrucciones De Funcionamiento Y Seguridad página 7

BM 1619929E58 06-09:BM 1619929E58 06-09 6/8/09 3:19 PM Page 7
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING SDS-plus
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 2).
FIG. 2
®
SDS-plus CHUCK
DUST SHIELD
Note: when replacing original SDS-plus quick
change chuck, always make sure the replace-
ment chuck has the proper number of
identification grooves.
REMOVING THE SDS-plus
QUICK CHANGE CHUCK
(Model RH328VCQ only)
Grasp the locking ring of the SDS-plus quick
change chuck and pull forcefully in direction of
arrow A while pulling chuck in direction of
FIG. 4
LOCKING
RING
®
SDS-plus QUICK
CH NGE CHUCK
B
All manuals and user guides at all-guides.com
Assembly
NOTE: The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
®
ACCESSORIES
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
FIG. 3
arrow B and remove from tool (Fig. 4).
® Before attaching the chuck apply a light coat of
grease to end of the shank.
Grasp the SDS-plus chuck firmly with your
hand and push it onto the tool with a twisting
motion until you hear it lock into place (Fig. 5).
FIG. 5
IDENTIFIC TION
A
-7-
REMOVING SDS-plus ® ACCESSORIES
Accessories may be hot after
W RNING
use. Avoid contact with skin
LOCKING SLEEVE
ATTACHING SDS-plus
QUICK CHANGE CHUCK
(Model RH328VCQ only)
GROOVES
®