Working Tool; Selecting The Right Working Tool; Narrow Chisel; Moil Point - Chicago Pneumatic CP 0016 Manual De Instrucciones

Safety and operating instructions
Use a synthetic lubricant such as CP Airolene Plus
Tool Oil or mineral oil with the properties
recommended in the table below.
Lubricant Temperature
range °F (°C)
CP Airolene Plus -4 to +120
Tool Oil
(-20 to +50)
Air tool oil -4 to +60
(-20 to +15)
Air tool oil +60 to +120
(+15 to +50)
It is recommended that the oil contains a rust-
inhibitor.

Working tool

CAUTION Hot working tool
The tip of the working tool can become hot and
sharp when used. Touching it can lead to burns
and cuts.
Never touch a hot or sharp working tool.
►
Wait until the working tool has cooled down
►
before carrying out maintenance work.
NOTICE
Never cool a hot working tool in water, it
can result in brittleness and early failure.

Selecting the right working tool

Selecting the right working tool is a precondition for
proper machine function. It is important to select
working tools of high quality to avoid unnecessary
machine damage.
The machine can be destroyed if you use an
incorrect working tool.
Recommended working tools are listed in the
machine's spare parts list.

Narrow chisel

Moil point

16
All manuals and user guides at all-guides.com
Viscosity
-
100-150 SUS
(ISO VG 22-32)
225-350 SUS
(ISO VG 46-68)
The narrow chisel is used for
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
CP 0016, 4130, 4131, 4132, 4134

Wide bladed chisel

WARNING Vibration hazard
Using inserted tools that do not fulfil the criteria
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is well-
►
maintained, not worn out and of the proper size.
Always use a sharp tool in order to work
►
efficiently.

Fitting and removing the working tool

Whenever fitting or removing the working tool the
following instructions must be observed:
To prevent an accidental start: switch off the
◆
power supply and disconnect the machine from
the power source. Bleed the machine by
pressing the start and stop device.
◆ Before inserting a tool, lubricate the tool shank
with grease.
Close the tool retainer and check the lock
◆
function by tugging the inserted tool sharply
outwards.
A
CP 0016
1. Slide the retainer over the shank and collar
onto the chisel.
2. Open the buffer (A) and place it on the chisel
between the retainer and the collar.
9800 0616 71 | Original instructions
The wide bladed chisel is
used in soft materials, such as
asphalt and frozen ground.