Brightness; Daylinght Saving Time; Recording Menu; Recording Menu Basic Settings - urmet domus 1093/064 Guía Rápida

2.1.2.4

Brightness

This option can be used to vary the OSD menu brightness.
Use "▲▼" to select.
2.1.2.5

Daylinght saving time

This option is used to automatically set time changes (to and from summer saving time).
When the "ORA LEGALE" is on, the clock will be automatically set back by one hour when winter time comes into effect, while it
will be automatically set forward by one hour when summer saving time comes into effect.
Press "ENTER" to access the submenu. Symbol " " in the check box indicates that the setting is enabled; symbol "×" indicates
that it is not.
Press "◄►" to go from one submenu option to another and press "▲▼" to set. Select "CONFIRM" and press "ENTER" to make
the changes effective.
After confirming the setting, in live and play modes, letter "E" or "I" will appear by the side of the date/time indicating summer
(when summer saving time is applied) or winter (when it is not) as shown below:
2.2

RECORDING MENU

Description
This menu is used to edit the recording and configuration settings of each video signal.
Position the "Active Frame" on the "RECORDING" icon and press "ENTER".
The following window will appear:
This page contains the basic menu settings.
Select "SETUP" and press "ENTER" to access advanced settings.
The selected item is highlighted.
Press arrows "◄►" to point the cursor to the various menu items.
Select "CONFIRM" and press "ENTER" to make the changes effective.
Select "CANCEL" and press "ENTER" to cancel the changes.
Press "ESC" to go back by one step.
Press "ESC" several times until the configuration window closes to quit the configuration menu.
IMPORTANT NOTE
Reboot the device to make the variations of some settings effective.
2.2.1

RECORDING MENU BASIC SETTINGS

2.2.1.1

Hard disk full

This option can be selected to define the recording method to be used when hard disk capacity is exceeded.
Possible options are: "overwrite" and "stop recording".
In overwrite mode ("overwrite" option), the recording writes over previously stored data.
If "stop recording" is selected, the recording will stop when the maximum capacity of the hard disk is reached.
If several hard disks are present in the DVR, the system will start writing on the SLAVE (secondary) disks when the MASTER
(main) disk is full. When the SLAVE disk is full, the system will start writing over the MASTER disk (if "overwrite" option is
checked) and then back on the SLAVE disks.
DS1093-013
All manuals and user guides at all-guides.com
22-11-2006 MER 11:35:00 (I)
Figure 26: recording menu (basic settings)
38