Warning Signals - Metabo HPT RH18DA Instrucciones De Seguridad Y Manual De Instrucciones

English
4. Forming resin pipes (Fig. 16)
Use nozzle (curved surface) to evenly heat the
circumference of the resin pipe.
To prevent the inside of the pipe from narrowing when
bending it, etc., pour sand inside, block both ends and
then gently bend it.
Nozzle (Curved surface)
5. Defrosting water pipes (Fig. 17)
Use nozzle (curved surface) to heat the frozen area
from the edge to the center. Do not mistake gas pipes
for water pipes and heat them.
Take care to avoid damaging frozen resin areas on
water pipes.
Nozzle
(Curved surface)
18
Fig. 16
Fig. 17

WARNING SIGNALS

This product features functions that are designed to
protect the tool itself as well as the battery. If any of the
safeguard functions are triggered during work, the LED
light and the temperature display will blink for a few
seconds as described in Table 7.
When any of the safeguard functions are triggered,
immediately switch off and follow the instructions
described under corrective action.
Safeguard LED light
Function Display
Overload
Protection
On 0.5 sec./
off 0.5 sec.
Temperature
Protection
Table 7
Corrective
Display
Action
Remove the
cause of the
overload.
Allow the tool
and battery
to thoroughly
cool.