Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
APPLICATIONS
When observing the safety rules and using the metabo
HPT-specifi ed accessories, this Cordless Heat Gun is
intended for all applications with hot air that are listed in
these operating instruction.
Applications
○ Shrinking of shrink down tubing, solder connectors
and solder terminals, packaging and electrical
components.
○ Deforming of articles made from acrylic, PVC, and
polystyrene, tubing, plates and profi les, as well as
moist woods.
○ Welding of thermoplastic polymer, fl ooring materials
of PVC and linoleum, PVC-coated fabric, tarpaulins
and foils.
○ Soldering of tin, special silver solder, SMD elements,
cable lugs, and for loosening soldered connections.
○ Paint removal –Removal of old and even thick
coatings of oil paint, varnish and synthetic plaster.
○ Drying of colour shade samples, fi lter, adhesives,
construction joints and stucco forms.
○ Joining
adhesives-Large-surface
contact adhesives, activation of pressure-sensitive
adhesives, acceleration of bonding processes,
releasing of bonding points as well as releasing or
bonding of edge bond or veneer.
○ Defrosting of icy stairs and steps, door locks, trunk
lids, car doors or water pipes, as well as for defrosting
refrigerators and ice boxes.
○ Disinfection-With hot air of 1,022°F (550°C), you
can quickly rid animal sties/stables of bacteria.
Woodworm infestation can be controlled (Caution:
Danger of fi re! Do not heat up the wooden surface
excessively).
INSTALLING AND REMOVING THE
BATTERY
○
How to install the battery.
Align the battery with the groove in tool and slip it into
place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
○
How to remove the battery.
Withdraw battery from the tool while pressing the latch
(2 pcs) of the battery (Fig. 5).
12
ASSEMBLY AND OPERATION
gluing
with
Battery
Insert
Pull out
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○
The power source voltage is stated on the nameplate.
○
The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1.
Connect the charger's power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
Push
Latch
Fig. 5
Tabla de contenido
