Trouble Shooting; Repairs - probst AKZ-UNI-850 Instrucciones De Uso

Maintenance and care
6.2

Trouble shooting

ERROR
The clamping-power is not big enough,
the load is slipping out
(optional)
(optional)
(Adjustment of the opening width)
(optional)
(Pneumatics / Hydraulics)
(optional)
(Electrics) (optional)
(Property of material)
The clamping-power is fading
(Pneumatics / Hydraulics)
(optional)
Unbalanced load
(Adjustment of the gripping range)
(optional)
The gripping arms are not working
synchronous
(Rack gear adjustment) (optional)
(Pneumatics / Hydraulics) (optional)
6.3

Repairs

Only persons with the appropriate knowledge and ability are allowed to repair the device.
Before the device is used again, it has to be checked by an expert.
5610XXXX-YYYY
CAUSE
The grippers are worn
The maximum load is exceed
The actual opening width is not correct Adjust the opening width according to
The working pressure is not big enough Adjust the working pressure (see
The electric motor is faulty.
The surface of the material is dirty or
the material is not suitable / allowed for
this device.
The system is not tight
The cylinder can not control the
pressure.
The valves are faulty.
Missing or not enough lubrication on
moving parts such as sliding guides,
racks gears and the like.
The device is not loaded symmetrically
The adjustment of the gripping rangeh
is not symmetrical.
The rack gear adjustment is faulty
The dividing valve is faulty
23 / 26
REPAIR
Replace the grippers
Reduce the weight of. the load
the load you want to transport
technical data)
Check the electric motor
Check the surface of the material or ask
the manufacturer, if you the material is
allowed for this device.
Check all Connections , fittings, pipes
and hoses.
Check the seal kits of the cylinders
Check the valves
Lubricate / grease components
accordingly (see chapter
"Maintenance").
Adjust the position of the load
Correct the adjustment of the gripping
range
Check the rack gear adjustment and
repair it
Check the dividing valve
GB