Metabo HPT M 18DYA Manual De Instrucciones página 14

English
(2) While pressing the lock button and securing the
shaft in place, attach the collet nut, insert the bit, and
tighten the collet nut. (Fig. 10-b)
Collet (1/8")
Collet nut
Collet (1/4")
Collet nut
Bit (1/4")
OPERATION
WARNING
● To avoid serious accident, ensure the switch is in
the OFF position, and pull out the battery.
● Wear eye protection when operating this tool.
● Keep your hands, face and other body parts
away from the bits and any other rotating parts,
while operating the tool.
CAUTION
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Pull out the battery after completing operation.
1. Adjusting the depth of cut (Fig. 11)
Loosen the knob bolt, and adjust the depth guide
(dust adapter) by sliding it.
14
Lock button
Shuft
Push
a
Collet (1/4")
b
Fig. 10
Depth guide
Loosen
NOTE
○ The depth guide (dust adapter) should be adjusted
before each cut.
○ Adjust the tip of the bit so that it protrudes at least
3 mm from the material for a clean fi nish.
2. Switch operation
WARNING
Ensure that the switch is in the OFF position
before installing the battery.
Pressing the ON side ("I") of the switch activates
it, and pressing the OFF side ("O") stops it. When
the switch is in the center position, it is in the
"OFF" state. (Fig. 12)
Switch
Push
"ON" state
3. How to use the LED light (Fig. 13)
When the switch is turned ON, the LED light will light
the area at the tip of the tool.
When the switch is turned OFF, the LED light will
automatically power off .
LED light
Tighten
Knob bolt
Fig. 11
Push
"OFF" state
(Center position)
Fig. 12
Switch
Fig. 13