Bosch T4B Instrucciones De Funcionamiento Y Seguridad página 10

Remove Saw From Stand
(with tool mounts attached)
1. Press the unlock button on each tool
mount and open the release lever to the
unlocked position (see fig. 10, p8).
2. Locate the carry handles at the base of the
saw. Place one hand on the saw base
handle and the second on the saw's top
handle, as shown in figure 14. Holding
tightly, tilt the saw (with the tool mounts
still attached) toward yourself and lift it
from the stand.
Attach the Saw to the Stand
(with tool mounts attached)
1. Make sure the tool mount release levers
on each mount are in the open and
unlocked position (see fig. 10, p8).
2. Locate the carry handles at the base of the
saw. Place one hand on the saw base
handle and the second on the saw's top
handle. Lift the saw to the rail assembly.
3. Line up the left tool mount next to the red
secondary stop on the rail assembly as
close as possible.
4. Tilt the saw until the front jaws of both tool
mounts are engaged to the rail. With both
hands on the saw handles, guide the saw
back to its level position on the rail (see
fig. 7, p8).
5. Push the release lever on each tool mount
to the locked position.
Be sure both tool mount
W RNING
levers are in the locked
position before operating or transporting the
saw.
Expansion Rail Adjustment
1. Loosen the locking knob located along the
side of the rail assembly, as shown in
figure 15.
2. Extend expansion rail to desired length
and retighten locking knob before
beginning work.
3. Repeat process for opposite side.
FIG. 14
FIG. 15
-10-