1.
Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Failure to comply with the operating instructions
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manual
before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and
extending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations
applicable to the operation of the device in your country.
Keep the operating manual package with the machine
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and carefully
observed by all operating personnel before starting the
work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
22 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. A)
1.
Transport handle
2.
Indicator lamp for overheating
3.
Indicator lamp for operation
4.
Potentiometer for adjusting the material thickness
5.
Side cover
6.
Locking mechanism
7.
Hose assembly with direct connection
8.
Burner
9.
Burner button
10. Burner nozzle
11. Nozzle holder
12. Contact tip
13. Earth cable with earth clamp
14. On/off switch
3. Scope of delivery
A. Combination wire brush with slag hammer
B.
Welding mask
C. Operating instructions
D. Welding machine
E.
Flux-cored wire rolls (3x)
4. Proper use
The flux-cored wire welding machine is suitable for
self-shielded flux-cored wire welding and the use of
the corresponding wire. No additional gas is required.
The shielding gas, contained in the wire in a powdered
form, is thereby guided directly into the electric arc and
makes the device resistant to the wind when working
outdoors.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator,
not the manufacturer, is responsible for damages or
injuries of any type resulting from this.
www.scheppach.com