Operation; Running A Program; Program End - ADC EcoWash EWH-25 M Manual De Uso Y Mantenimiento

3.1 Operation

This machine has been designed to wash or treat most
materials. Its use for other purposes than those given
is considered as undue and dangerous.
The machine should be loaded with the nominal load,
smaller or bigger loads should be avoided.
Clothes should not be washed in sacks or cloth bags.
If this is absolutely necessary, make sure the machine
is loaded to the nominal load to avoid possible
unbalanced loads.
Canvas, waterproof items, mops, carpets or rugs
should not be spun.
The machine is controlled using a microprocessor able
to adapt to the needs of each user.
There are 7 programs, which can be modified to
varying degrees. In the standard cycles (P1, P2, P3 &
P4), it is possible to change the time of each cycle,
making the same changes to all four programs. The
cycle times for the extended programs (P5 and P6)
can also be changed, without affecting the other
programs. Lastly, in OPL mode, it is possible to
configure P7, which offers more options, allowing the
cycle time, the wash temperature and the spin speed
to be changed.
For further details,
Configuration and Standardised Programs.
The machine has an intelligent control to control the
water temperature; if hot water is available, it should
be connected. The machine adjusts the different water
inputs to maintain the programmed temperature.
It has intelligent control for spin cycle management.
The washer extractor controls any unbalanced loads
and manages the spin to ensure a good spin, reducing
noise and extending the useful life of wearable
components, thus significantly reducing fatigue in the
mechanical components.
3.1.1

Running a program

In order to carry out a wash program, the following
steps should be followed:
please see the sections
1- Put garments to be cleaned in washer
extractor drum.
2- Close washer extractor door.
3- Add detergent.
4- Select desired program.
5- Press START key.
After starting a program, the LEDs indicate its
condition and evolution.
With the START key the program stops, and pauses. If
you want the program to continue, press the Start key
again. If the program is in spin mode, it is not possible
to pause the machine, and therefore pressing the
START key will have no effect.
3.1.2
The program can finish in several ways:

Normal end: the program finishes when all cycles
have been carried out.

By pressing the ESC key when the washer
extractor is in PAUSE mode.

By pressing the ADVANCE key from any point in
the program, repeatedly, the end of the program
can be reached. If a spin is being carried out, the
ADVANCE key will not respond until the braking
safety time has finished (approx 1 min.).
When a program ends, before allowing the door to be
opened, the clothes are untangled during 30 seconds.
An acoustic signal indicates when the door can be
opened.
12

Program end