Cleaning; Cleaning The Tine Axle Shaft; Storage; Storage Safety - Toro 58604 Manual Del Operador

Cleaning

Cleaning the Tine Axle
Shaft
Service Interval: Every 10 hours
Remove all vegetation, string, wire, and other material
that may have accumulated on the axle between the
inner tines and the transmission housing.

Storage

Storage Safety

•
Shut off the machine and wait for all moving parts
to stop before you leave the operator's position.
Disconnect the spark-plug wire, keep it away from
the plug to prevent accidental starting, and allow
the machine to cool before adjusting, fueling,
unclogging, servicing, cleaning, or storing the
machine.
•
Run the engine dry or remove the fuel with a hand
pump; never siphon the fuel. If you must drain the
fuel tank, do it outdoors.
•
Follow the instructions in this Operator's Manual
to safely unload, transport, and store the machine.
•
Do not store the machine with fuel in the fuel
tank inside a building where ignition sources are
present, such as hot water and space heaters and
clothes dryers. Allow the engine to cool before
storing the machine in an enclosure.
•
Always refer to the Operator's Manual for
important details if the machine is to be stored for
an extended period.

Storing the Machine

1. Park the machine on a level surface, shut off
the engine, and wait for all moving parts to stop
before leaving the operating position.
2. Remove debris from the tines, axle, transmission
housing, and engine.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
engine and transmission.
3. Coat the axles lightly with axle grease.
4. Service the air cleaner; refer to
Cleaner (page
5. Change the engine oil; refer to
Engine Oil (page
6. Prepare the machine for storage for over
30 days as follows:
A. Add fuel stabilizer/conditioner to fresh fuel
in the tank. Follow mixing instructions from
the fuel stabilizer manufacturer. Do not
use an alcohol-based stabilizer (ethanol or
methanol).
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and
drain the fuel tank.
25
Servicing the Air
19).
Changing the
20).