Setting The Alarm Time - Technoline WS 8011 Manual De Instrucciones

● Press [ TIME SET ] button to save the setting and return to normal time mode. Or the
clock will automatically exit the setting mode after 1 minute without pressing any button.
● When setting second, press
Note:

SETTING THE ALARM TIME

● In normal time mode, press [ ALARM SET ] button to enter alarm time mode.
Press and hold [ ALARM SET ] for 3 seconds until Hour digit flashes.
● Press
[ +/CHANNEL ] / [ -/MEM ]
● Press [ ALARM SET ] button again to step to Minute setting.
Press [ +/CHANNEL ] / [ -/MEM ]
● Press [ ALARM SET ] button to save the setting and return to normal time mode. Or the
clock will automatically exit the setting mode after 1 minute without pressing any button.
Note: After pressing [ +/CHANNEL ] / [ -/MEM ] button, alarm function is automatically turned
on (icon " " displayed).
USING THE ALARM AND SNOOZE
● In normal time mode, press [ ALARM SET ] button to enter alarm time mode.
Press [ ALARM SET ] button again to turn on (icon "
function.
If alarm is turned on, alarm beeps at the alarm time.
Alarm beeping can be stopped by:
● Auto stop if no button is pressed during alarm sound beeping. Alarm beeping lasts for 2
minutes.
● Press [ SNOOZE ] button to stop the current alarm and enter snooze. Alarm icon will be
flashing continuously. The alarm will sound again in 5 minutes.
Snooze can be operated continuously in 24 hours.
● Press [ ALARM SET ] button to turn off alarm function.
TEMPERATURE AND HUMIDITY DISPLAY
Slide [°C/°F] switch on main unit to <°C> or <°F>.
To read outdoor temperature and humidity
The default displayed channel is channel 1.
1. In normal mode, press [ +/CHANNEL ] button repeatedly to view readings of channel 1, 2
and 3.
2. Press and hold [ +/CHANNEL ] button for 2 seconds to enter channel auto-change,and
channels change automatically in every 4 seconds.
3. Press [ +/CHANNEL ] again to return to normal mode.
Note: 1. Once the channel is assigned to one sensor, you can only change it by removing
the batteries or resetting the unit.
2. If no signals are received or the transmission is interfered, "---" will appear on the
LCD.
3. Relocate the main unit and sensor in other positions and make sure the
transmission is within the effective range of 30 meters approx.
4. Try out where your multifunctional main unit receives the signals best.
VIEWING MAXIMUM AND MINIMUM RECORDS
[ +/CHANNEL ] / [ -/MEM ]
button to set its value.
button to set its value.
button to set its value to 00.
" displayed) or turn off alarm
GB 4