Idiomas disponibles
Idiomas disponibles
LA-ITR-SH
Line Interactive Sinewave UPS
1. Product Overview
Front View:
LCD panel
Power switch
Back View:
LA-ITR-1000SH
Output receptacles
Modem/Phone/Network surge protection
AC input
USB com. port
Circuit breaker
____________________________________________________
LA-ITR-SH (V.1.2 2019)
EN
Input voltage
Output voltage
AC mode indicator
Load level
Overload indicator
Battery mode indicator
Battery level
Low battery indicator
Fault indicator
LA-ITR-1500SH/ LA-ITR-2000SH
2. Installation and Initial Startup
NOTE: Before installation, please inspect the unit. Be sure that nothing inside
the package is damaged.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow.
Please place the UPS away from other units at least 20 cm to avoid interference. Do NOT
operate the UPS where the temperature and humidity is outside the specific limits. (Please
check the specs for the limitations.)
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best results,
suggest to charge the battery at least 6 hours before initial use.
The unit charges its battery while connecting to the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the
power switch of UPS unit, then devices connected to the UPS will be protected by UPS unit.
Connect Modem/Phone/Network for Surge Protection
Connect a single modem/phone line into surge-protected "IN" outlet on the back panel of
the UPS unit. Connect from "OUT" outlet to the computer with another phone line cable.
Connect Communication Cable
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB port and the other to the communication port of
your PC. With the monitoring software installed, you can schedule UPS shutdown/start-up
and monitor UPS status through PC.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again
the power switch.
3. Important Safety Warning (SAVE THESE INSTRUCTIONS)
Please comply with all warnings and operating instructions in this manual strictly. Save this
manual properly and read carefully the following instructions before installing the unit. Do
not operate this unit before reading through all safety information and operating instructions
carefully.
_________________________________________________
6 hours
LA-ITR-SH (V.1.2 2019)
