Worx WX670 Manual página 11

to set the optimum oscillating frequency
according to the accessories used and the
respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone
and metal.
Low oscillation frequency:
Polishing varnishes.
5. securing the Work piece
caution: Before working your tool
make sure that no live cables will be
damaged.
Warning: Do not touch the gear box
after long working time, because it
could be hot.
sanding
Typical application: wood, metal; small areas,
especially corners, edges and places difficult
to access.
Select high oscillation frequency(WX671).
Sanding with a constant movement and light
pressure.
Pressing on heavily does not increase the
removal – the sanding sheet merely becomes
worn faster.
sawing with the segment saw blade
Typical application: wood, plastics, sheet
metal.
Select high oscillation frequency(WX671).
The saw blade lasts longer if the wear
is distributed evenly. To ensure an even
distribution, loosen the saw blade, turn it
round a little and then tighten again firmly.
sawing with the standard straight cutter
(see c)
Warning: the sawing teeth are
very sharp. do not touch during
mounting and application.
The workpiece must be inserted firmly or
clamped tightly before it is processed.
Typical application: wood, plaster board and
soft plastics. Not suitable for metal (e. g. nails)
and stone.
When plunging and sawing with a slight
pendulum motion, make sure that sufficient
chip removal is provided for.
High frequency multi-function tool
All manuals and user guides at all-guides.com
WORKING HINTS FOR
YOUR TOOL
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speeds. Always keep the
blade sharp.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the cutting or sanding finish.
Start your tool before working and turn it off
only after you stop working.
Do not start sanding without having the
sandpaper fitted.
Do not allow the sandpaper to wear away , it
will damage the sanding pad. The guarantee
does not cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for the final surfaces. If necessary, first make a
test run on scrap material.
Excessive force will reduce the working efficiency and cause motor overload.
Replacing the accessory regularly will
maintain optimum working efficiency.
MAINTENANCE
remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally
you may see sparks through the ventilation
slots. This is normal and will not damage your
power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
11
EN