Connecting Electricity - Haier DD410RS Instrucciones De Instalación Y Manual Del Usuario

INSTALLATION REQUIREMENTS

CONNECTING ELECTRICITY

WARNING
Plug into a grounded 3-prong outlet.
Do not remove the ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
Do not, under any circumstances, cut or remove the third (ground)
prong from the power cord. For personal safety, this appliance must
be properly grounded.
The power cord of this appliance is equipped with a 3-prong (grounding)
plug which mates with a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified electrician to make
sure the outlet is properly grounded.
Where a standard 2-prong wall outlet is encountered, it is your personal
responsibility and obligation to have it replaced with a properly grounded
3-prong wall outlet.
The dual-drawer refrigerator should always be plugged into its own
individual electrical outlet which has a voltage rating that matches the
rating plate.
A 115 Volt AC, 60 Hz, 15- or 20-amp fused, grounded electrical supply
is required. This provides the best performance and also prevents
overloading house wiring circuits which could cause a fire hazard from
overheated wires.
Never unplug your dual-drawer refrigerator by pulling on the power cord.
Always grip plug firmly and pull straight out from the outlet.
Immediately discontinue use of a damaged supply cord. If the supply
cord is damaged, it must be replaced by a qualified service professional
with an authorized service part from the manufacturer.
When moving the dual-drawer refrigerator away from the wall, be
careful not to roll over or damage the power cord.
NOTE: Before performing any type of installation or cleaning, disconnect
the dual-drawer refrigerator from the electrical source. When you are
finished, reconnect the dual-drawer refrigerator to the electrical source
and reset the temperature controls to the desired setting.
8
ELECTRICAL SHOCK HAZARD
49-60810