Installation Instructions; Step 1 - Unpack Dual-Drawer Refrigerator - Haier DD410RS Instrucciones De Instalación Y Manual Del Usuario

INSTALLATION INSTRUCTIONS

STEP 1 - UNPACK DUAL-DRAWER REFRIGERATOR

WARNING
EXCESS WEIGHT HAZARD
Use two or more people to move and install dual-drawer refrigerator.
Failure to do so can result in back or other injury.
WARNING
Cabinet edges along stamp/cut-out areas may be sharp. Avoid placing
hands, fingers or other appendages near these areas.
Failure to do so can result in cuts.
IMPORTANT: Handle with care when moving dual-drawer refrigerator to
avoid either damaging the refrigerant tubing or increasing the risk of a leak.
IMPORTANT: When moving the dual-drawer refrigerator, never tilt it more
than a 45° angle. This could damage the compressor and the sealed system.
If the dual-drawer refrigerator has been placed in a horizontal position for
any period of time, wait 30 minutes before plugging in the refrigerator to
allow the refrigerant to settle.
REMOVE PACKAGING
Remove tape and glue residue from surfaces before turning on the
dual-drawer refrigerator. Rub a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
NOTE: Do not use sharp instruments, rubbing alcohol, flammable fluids,
or abrasive cleaners to remove tape or glue. These products can damage
the surface of your dual-drawer refrigerator. For more information, see
"Dual-Drawer Refrigerator Safety."
Dispose of/recycle all packaging materials.
CLEAN BEFORE USING
After you remove all of the packaging materials, clean the inside of the dual-
drawer refrigerator before using it. See the cleaning instructions in "Dual-
Drawer Refrigerator Care."
49-60810
CUT HAZARD
9