BE Power Equipment P2115EN Manual Del Operador página 8

ASSEMBLY INSTRUCTIONS
3
High Pressure Hose Assembly
Screw high pressure hose (D) clockwise onto bottom front of
power washer unit (A). Pull back collar and insert o-ring post
into water outlet far enough so collar can thread onto outlet
threads until hand tight. If it takes fewer than six turns you have
not properly tightened the high pressure hose fitting. It is easier
to position the power washer in front of you to ensure that the
threads are started correctly. Failure to properly tighten high
pressure hose will result in the hose slipping or popping off
immediately upon turning unit on. Do not worry about damage if
this occurs–just reinstall and take extra care when screwing on
the high pressure hose fitting.
Note: DO NOT use pliers or locking pliers to tighten.
5
I
3
D
2
Twist collar then pull back to release the the high
pressure hose (D) connection from the gun (I).
8
A
D
1
3
D
4
I
D
1
Pull back on collar at the other end of the high pressure hose
(D). Push firmly to connect hose to spray gun (I). Twist collar to
secure. Confirm hose is locked into spray
gun by slightly pulling on them. The hose is now
securely attached to spray gun.
6
1
Unlocked
Locking Spray Gun (Before Lance Installation)
To lock trigger of spray gun (I), point gun away
from you and turn dial to lock ("3" and "9" position).
Squeeze or pull trigger to make sure it is locked.
ALWAYS leave in locked position when not in
use. This ensures the gun is in "safe" mode until it
is ready for use. Turn dial to unlock ("12" and "6"
position) to release spray gun trigger.
Note: The trigger lock prevents trigger from being
accidentally engaged.
2
3
D
I
Locked
bepowerequipment.com