Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
7.2 Power Connection
The equipment must be operated by professionals; Make sure that the voltage of
power supply must be comply with the voltage identified on the device, and must have an
overload or leakage electrical protection.
ATTENTION!
The equipment directly connected to the power supply.
Factory has equipped the standard 3 pin plug socket. Connect the power supply as below table.
Yellow and green wire could be connect to ground.
If the cable of the fixture is damaged, replacement should be operate by factory or qualified staff.
Wire Colour
Brown
Blue
Yellow+Green
8. CONTROL PANEL MENU OPERATE
1: The indicating arrow in the right below is enter the menu (click the menu).
2: The touch screen display have four operation key : Exit, Upward, Downward, Enter , press it will
execute orders accordingly.
3: Can change the parameter Settings directly on the touch screen
4: Also can use the wheel on the left side of touch screen to change the parameter Settings
5: The equipment have built-in temperature sensor, the temperature will display on the bottom left
corner of touch screen. When over the rated temperature, the equipment will start the automatic
protection function.
6: When the equipment receive the DMX512 signal,the blue ligh t on the top right lights up , the
left side show have connected the XLR Socket. .
CONTROL PANEL MENU OPERATE
Address
Special
SIDIUS LED 285/4
Live wire
Ground wire
DMX Address number set
Transfer Rate
Data
Signal quality
Start Code
Fixed ID set
Return
White Balance
User Manual/Manual de uso
Plug
Null
001-512
029
506
100%
000
0-4096
Off
Mark
L
N
7
Tabla de contenido
