Mark SIDIUS LED 285/4 Instrucciones De Usuario página 7

DMX 512 signal amplifier.
Do not use two outputs to separate the connection, if separate a continuous connection
to branch, DMX512 splitter is necessary.
Attention! vertically up to put the fixture, the sh ortest safe distance between the
fixtures must be ≥900 mm, the installation layout diagram as shown in the picture.
To prevent the reflection and interference of receiving the control signals, we must
install a terminal plug at the end of each branch of 3pin or 5pin output socket. Terminal plug
(welding a 0.25W 120 Ω
6.4 CABLE CONNECTION
Connect the DMX data: from the controller to the nearest controller equipment 3pin or 5pin
socket , and then from this equipment output connected to the next equipment input, like this
continuous connecting, finally the output of the terminal equipment for the data cable insert a
terminal plug .
If use DMX512 distributor, the controller connect to the DMX512 distributor's input firstly,
then connect the next equipment from the output of the distributor, according to this method,
Finally match the terminal plug .
7. AC power . .
7.1 VOLTAGE , FUSE SPECIFICATION
Input Voltage
200 -240V
100 -120V
SIDIUS LED 285/4
resistor between the 2 and 3 pin of 3pin or 5 pin socket.
Fuse
5A 5×20 （Main fuse ）
10A 5×20 （Main fuse ）
User Manual/Manual de uso 6
EN