ARIETE 1312 Manual De Instrucciones página 44

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
Warning!
In case of dysfunctions, immediately turn off the appliance and unplug the power cord from the outlet.
PROBLEMS
CAUSES
The appliance is not
Air has probably entered the circuit
dispensing hot water
and deactivated the pump.
and/or steam.
The hole of the steam/hot water
wand is clogged.
There is little water and the pump
does not suck.
Coffee over owing
Probably too much ground coffee has
from the lter edges.
been put into the lter holder that has
prevented to fully tighten the lter
holder in its housing.
Ground coffee has remained on the
lter holder connection seat.
The spouts of the lter containing
coffee powder are clogged.
The coffee is too
Coffee grinding is too coarse.
watery and cold.
If this is the rst coffee you are
making, the lter might be cold.
The coffee grinder is
Impurities among coffee beans have
blocked or noisy.
caused the grinder to get blocked.
E cessive amount of
The amount of distributed coffee for
distributed coffee.
adjusted.
E cessive amount of
The amount of ground coffee for
ground coffee in the
lter.
adjusted.
During steam
The noise is due to the water pump
distribution, the
which is working at higher pressures
appliance makes
during steam distribution.
noise.
During coffee
There is little water and the pump
distribution, the
does not suck.
appliance makes an
unusual noise.
44
or cups has not been properly
or cups has not been properly
REMEDIES
Check that the water tank is properly inserted and
that the level does not drop below the minimum level
indicated on the tank.
Remove possible scale deposits from the nozzle hole
by using the provided needle.
Turn off the appliance.
Remove the tank. Check the tank water level is correct.
If needed, ll the water tank with fresh water up to the
MAX level. Insert the water tank into its seat (Fig. 9).
Switch on the appliance.
If problem persists, call the Service Centre.
Remove and disconnect the lter holder slowly
because any remaining pressure could cause splashes
or sprays. Clean the coupling seat with a sponge (Fig.
). Reduce the amount of ground coffee and repeat
the procedure.
Clean the gasket again with a sponge (Fig.
Remove and disconnect the lter holder slowly
because any remaining pressure could cause splashes
or sprays. Clean the lter spouts by means of a brush
or the provided needle. Clean the lter as described in
paragraph "Cleaning cycle".
To obtain a more concentrated and hotter coffee, you
must use a more nely grounded blend.
Try using a ner grinding level.
Try to heat up the lter before making coffee as
described in paragraph "How to distribute coffee for
coffee and milk-based beverages".
Read paragraph "Unlocking the coffee grinder".
Reduce the amount of distributed coffee.
Reduce the amount of ground coffee.
o intervention needed. Proper operation.
Turn off the appliance.
Remove the tank. Check the tank water level is correct.
If needed, ll the water tank with fresh water up to the
MAX level. Insert the water tank into its seat (Fig. 9).
Switch on the appliance.
If problem persists, call the Service Centre.
).
Tabla de contenido
loading

Tabla de contenido