TRAPP Master 500L Manual De Instrucciones página 32

Replacement of the nylon line
The life of the nylon line depends on the skill
 
the operator has to avoid contact with stones,
walls, fences and sidewalks. Frequent contact
with those obstacles cause premature wear
out of the nylon line.
To substitute it, get a refill containing the
 
spool and the nylon line from TRAPP
technical assistance shop or from specialized
dealers.
How to remove and replace the
spool
Make sure the equipment is unplugged.
 
Turn the lawn mower/trimmer upwards.
 
Hold the spool base (6) with one hand and
 
with the other remove the spool cover (1)
turning it counterclockwise (as shown in the
spool cover).
After removing the spool (3), thoroughly
 
clean the equipment base, taking care not to
allow grass to fall in the motor compartment.
To replace the spool, pass the tip of the
 
nylon line (4) through hole (2), fit the spool
on cover (1), align the spool cover on the
base guide (5), press it downward and turn it
clockwise until you hear a "click".
1
3
7
6
32
All manuals and user guides at all-guides.com
2
4
5
When substituting the spool, refer to TRAPP codes:
Model
Master 500L/Super 500
Master 700L/Super 700
Master 800/1000 Plus and
Super 800/1000 Plus
Master 800/1000L, Super
800/1000 and Master AT 1500
Attention!
Whenever substituting the spool (refill), keep the
spring (7) to reuse it.
How to refill the spool
Should you prefer to refill the spool by yourself:
Only use a nylon line of the diameter
 
recommended for the model of your
equipment (see "Technical Specifications").
Nylon lines in a diameter other than the
 
specified may damage the motor and the
automatic advancing system.
Remove the spool and the rest of the nylon line.
 
Take one end of the wire and pass it through
 
hole (1) as shown in the picture.
Wind the wire in the direction indicated
 
by the arrow on the spool as uniformly
as possible. Follow the maximum length
recommended for your equipment (see
"Technical Specifications").
1
Advance and automatic cutting of
the nylon line
1. With the equipment running:
Slightly press the spool against the ground.
 
The nylon line will automatically be released.
The cutting blade fixed to the protection
device will limit the amount of wire released.
www.trapp.com.br
Code
2120-028
2120-028
2120-331
2120-004