Operation; Safety; Initial Use; Switching On - Beurer HD 75 Cosy Dark Grey Instrucciones De Uso

4. Operation

4.1 Safety

CAUTION
• The heated overblanket is fitted with the SAFETY SYSTEM. This electronic sensor technology
provides protection against overheating across the entire surface of the heated overblanket with
an automatic switch-off if there is a fault.
• Please note that, for safety reasons, the heated overblanket can no longer be operated after a fault
has occurred and must be sent to the specified service address.
• Do not connect the defective heated overblanket with another control of the same type. This would
trigger a permanent switch-off via the control safety system.

4.2 Initial use

• First, connect the control to the heated overblanket by inserting the plug-in
coupling.
• Then plug the mains plug into the socket.

4.3 Switching on

To switch the heated overblanket on, set the sliding switch for ON/OFF and temperature settings to setting
1, 2, 3, 4, 5 or 6.
When it is switched on, the indicator lamp (4) lights up.

4.4 Setting the temperature

Level 0: OFF
Level 1: minimum heat
Setting 2 - 5: individual heat setting
Level 6: maximum heat
NOTE
The fastest way to warm up the heated overblanket is to initially set the highest temperature setting.
WARNING
If the heated overblanket is being used over several hours, we recom-
mend that you set the lowest temperature setting on the control to avoid
the body overheating and thereby any potential burns to the skin or heat
stroke.

4.5 Automatic switch-off

This heated overblanket switches off automatically after 3 hours. Once the heated overblanket has switched
off, it is no longer heated and the indicator lamp flashes.
To switch on the heated overblanket again, first set the sliding switch for ON/OFF and temperature settings
to the OFF ( 0 ) position for 5 seconds. After about 5 seconds it is possible to switch it on again.

4.6 Switching off

To switch off the heated overblanket, slide the sliding switch for ON/OFF and temperature settings to the
OFF ( 0 ) position.
NOTE
If the heated overblanket is not being used for several days, slide the sliding switch for ON/OFF and
temperature settings to the OFF ( 0 ) position and remove the mains plug from the socket.
Then disconnect the control from the heated overblanket by unplugging the plug-in coupling.
13