Sony BRAVIA KD-85X85K Guía De Referencia página 9

Note
• If using an electric screwdriver, set the
torque at approximately 1.5 N·m {15 kgf·cm}.
• Be sure to fasten the Wall-Mount
Attachment when attaching them to the TV.
Use only a flat head screwdriver to install
the Wall-Mount Attachment. Use of another
tool might result in over torqueing the
Wall-Mount Attachment and damaging the
TV.
Detaching the Table-Top Stand from the
TV
1
Remove one side of the Table-Top
Stand at a time. Firmly hold the
Table-Top Stand securely with both
hands while the other people lift up
the TV.
2
Repeat the previous step and
remove the other side of the
Table-Top Stand.
Note
• Three or more people are required to detach
the Table-Top Stand.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the TV
as it may cause the TV set to fall resulting in
personal injury or physical damage to the
TV.
• Take care when handling the Table-Top
Stand to prevent damage to the TV.
• Be careful when lifting the TV as the
Table-Top Stand is detached, the Table-Top
Stand may topple over and cause personal
injury.
• Take care when removing the Table-Top
Stand from the TV to prevent it from falling
over and damaging the surface that the TV
is sitting on.
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on.
To avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
Optional Camera and
Microphone Unit (not
supplied) Cable
Management
Troubleshooting
General troubleshooting for issues like:
black screen, no sound, frozen picture, TV
does not respond, or network is lost, do the
following steps.
1
Restart your TV by pressing the power
button on the remote control for about
five seconds. The TV will restart. If the TV
does not recover, try unplugging the AC
power cord then press the power button
on the TV and release it. Wait for two
minutes, and plug in the AC power cord.
Or, press the power button on the TV for
about 40 seconds until the TV turns off.
2
Refer to the Help menu shown below.
3
Connect your TV to the Internet and
perform a software update. Sony
recommends you to keep your TV
software updated. Software updates
provide new features and performance
improvements.
4
Visit Sony support website (information
provided at the end of this manual).
5
Perform the factory data reset.
US
9
US