Active TIGERCUT 25 wireless Manual De Usuario página 15

EN
Pairing
Step 1: SHEARS pairing mode.
1. Press and hold the trigger.
2. Turn the power ON without release the trigger
3. Wait for consecutive 3 "beep"
4. Release the trigger. The shears display shows a moving dashed line . The shears are
waiting for the pairing with the extension.If the dashed line is not present, turn the
pruner OFF and repeat the operation.
Step 2: EXTENSION pairing mode.
1. Press and hold the trigger.
2. Press and hold the power button, without release the trigger, until the green LED
starts ashing (Fig. 1).
3. The emitted sound changes from intermittent to continuous
4. Release the trigger. At this point, the pairing was successful. If not, repeat the opera-
tion.
�
After the pruner have been successfully paired with the extension pole
for the rst time, it does not need to be paired again for subsequent uses.
ON/OFF SWITCH
11
LED