Dremel MM50 Instrucciones De Funcionamiento Y Seguridad página 12

1600A014GX MM50 08-18.qxp_MM50 8/23/18 9:10 AM Page 12
Please refer to figures 9 and 10 for further instruction on how to use your Dremel Multi-Max™.
Following these instructions will allow you to get the highest performance out of your oscilating tool.
CORRECT: Sand with a smooth
back and forth motion, allowing the
weight of the tool to do the work.
INCORRECT: Avoid sanding with
only the tip of the pad. Keep as
much sand paper in touch with the
work surface as possible.
CORRECT: Always sand with the
pad and sandpaper flat against the work surface. Work smoothly in a
back and forth motion.
INCORRECT: Avoid tipping the
pad. Always sand flat.
FIG. 9
CORRECT: Always cut with a
smooth back and forth motion.
Never force the blade. Apply light
pressure to guide the tool.
INCORRECT: Do not twist the tool
while cutting.This can cause the
blade to bind.
CORRECT: Make sure flexible
scraper blade flexes enough
INCORRECT: Avoid screw head
touching surface with flexible
scraper blade.
-12-
FIG. 10