golmar T-540 PLUS Guía Rápida página 3

PROGRAMMING
PROGRAMMING THE T540 PLUS SE TELEPHONE WITH A BUTTON PANEL
Locate the SW2 DIP switch situated on the top left-hand side of the back of the EL632/PLUS
module and set number 2 to ON. The door panel will reproduce a sound to advise that the system
has entered into programming mode.
Important: To perform this programming, the telephone's SW1 DIP switches should be set to
In systems with more than one door panel, only perform this procedure on the main panel of each
building.
Nota: To programme the telephone with a coded door panel or from a general door panel, see the
manual of the corresponding door panel.
Switch off the telephone to be programmed.
Once switched off, press the door release button.
While keeping the door release button pressed, switch on the
telephone.
To show that the system is ready for programming, the door panel and the
telephone handset will emit a number of tones (the LED on the telephone
will illuminate red), enabling the door release button to be released. To
establish audio communication with the door panel, lift the handset.
Press the button of the door panel that will call this telephone.
At this moment, the door panel and handset will emit a number of
tones (the LED on the telephone will blink red).
To programme the telephone as , press button
Master
(the telephone's LED will illuminate red).
To programme it as , press button once, and the status LED
Slave 1
will blink (green) once. Continue successively to
button four times, and the status LED will blink (green) four times.
To programme the telephone as
Slave + Intercom
the LED will blink (green) once. Then press button
(the telephone's LED will illuminate red).
Make a call to check that the telephone has been successfully
programmed. Programme the other telephones in the same way.
Once the programming has finished, set the programming switch to OFF.
Each apartment must only have one master unit; if there are parallel
telephones or monitors, they must be configured as slaves.
IMPORTANT: For advanced programming, optional connections and more information, see the T-540 PLUS
User Manual (code 50122199).
"
https://doc.golmar.es/search/manual/50122199
OFF .
M
for 3 seconds
S
Slave 4 , pressing
SI
, press button and
for 3 seconds
"
4
T-540
PLUS DIGITAL SYSTEM
Golmar se reserva el derecho a cualquier modificación sin previo aviso.
Golmar se réserve le droit de toute modification sans préavis .
Golmar reserves the right to make any modifications without prior notice.
SE
EN [email protected]
PLUS SE TELEPHONE
QUICK GUIDE
T -540 PLUS
www.golmar.es
Sistemas de comunicación S.A.
REV.0122
SE N E GR
EN