CAUTION: DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
IMPORTANT SAFETY INFORMATION
1. Use ONLY insulated staples or plastic ties to secure the cords.
2. Route and secure the cords so that they will not be pinched or damaged.
3. LED light output is strong enough to injure human eyes. Do NOT look directly at
exposed LEDs.
4. LEDs gradually emit less light over their lifetime.
5. Do NOT use with an extension cord, use ONLY with power strips that have integral
overcurrent protection.
6. Do NOT mount to surfaces less than ¼ in.
1
30
seconds
CC
Clean surface with rubbing alcohol. Remove red liner. Press two medium strips (CC) to the back of the fixture on each end for 9" bar.
Remove black liners. Press the fixture to surface with tab towards you. Press firmly for 30 sec.
Connect add-on bar onto the #UC1271-WH1-09LF3-G 3PK Starter Kit, for up to 6 bars total.Use provided cord clips (DD) where
additional wire control is needed. Peel the backing off each clip and mount where required.
SLOWLY
Slowly stretch each strip slowly against the surface at least 12 inches to release for the bar.
Luminaire additionnel 5CCT à DEL de 23 cm / 9 po pour éclairage en dessous d'un
Diffuser
Diffuseur
Difusor
linking cord
Cordon de raccordement
Cable de enlace
READ ENTIRE INSTALLATION PROCEDURE BEFORE YOU BEGIN!
WARNINGS AND CAUTIONS
Easy Installation Command
Add-On 9-in 5CCT LED Under Cabinet Light (Page 1)
Luz LED 5CCT de 9 pulgadas añadible para debajo de gabinetes (Página 5)
(1)12in
(1)30,5cm
* Los aditamentos reales pueden diferir de los que se muestran en la ilustración.
7. A. For installation with Command
stoves, beds or inside of enclosed cabinets. Do NOT mount on wallpaper.
B. For installation using screws: Do NOT mount over sinks, stoves, or inside of
enclosed cabinets.
8. Turn power off before servicing.
9. This add-on bar cannot be used on its own. It can only be used with the starter Kit
(Model#UC1271-WH1-09LF3-G). A maximum of 6 bars can be linked together.
10. NOT intended for recessed installation in ceiling or soffits.
11. Suitable for INDOOR damp locations ONLY.
®
Strips by 3M
2
DD
REMOVAL
Model / Model / Modelo #: UC1271-WH1-09LF1-G
AAx2
CCx2
Required/ Nécessaire/ Obligatorio
* Actual hardware may differ from illustration.
* La quincaillerie incluse peut être différente de l'illustration.
Strips by 3M: Do NOT mount over sinks,
®
meuble (Page 3)
BBx4
DDx2