User Operations - GBC SmartPunch Plus Manual De Instrucciones De Operación

4. USER OPERATIONS

A. Interchanging Die Sets:
Are completed without tools and only take seconds to perform
B. Punch Chip Container:
Easy-to-access chip tray for quick chip disposal
C. Die Set Storage:
Holds up to 2 spare Die Sets
D. Bypass:
Short straight-through paper path for unpunched documents
E. Punch/Crease/Perforation Mode Path:
Wide radius turn can support stocks up to 300g/m
Paper flow and User Interactive sections of SmartPunch Plus
A.
Your SmartPunch Plus offers the convenience of interchangeable die
sets, allowing you to economically punch, crease or perforate documents
for a wide variety of binding styles and applications. Changing the die
sets is both quick and easy, as the following instructions illustrate:
Note: For advanced Die Set Configuration instructions- See Section 8
Die Set User Manual.
Removing Die Sets from the Machine: The inter-changeable die set
slot of the SmartPunch Plus is located above the Punch Chip container
at the bottom of the punch.
Step 1: Stop the printer.
Step 2: Open the SmartPunch Plus access door panel.
Step 3: Securely grasp the die lock handle and rotate it in the CCW
2
cover
direction, as indicated in the label near the die lock handle. This
releases the die from the locked position.
Step 4: Slide the die set out until it is fully removed, supporting it
with both hands. Take care not to let the die identification chip
(located on the underside at the rear end) drop onto the die stop as
it leaves the machine.
Step 5: Properly store the removed Die Set in the Die Set storage
area. (keep away from dust, dirt, and possible accidental falls from
the edge of counters, etc.).
Step 6: Select the desired Die Set for your new job and slide it into
the Die Set slot. Push the Die set firmly until the Die stop feature
contacts the round magnet. This is critical in ensuring the proper
position of the die set.
Step 7: Grasp the handle and rotate it in CW direction until the latch
is fully engaged, as shown indicated in the label.
Please note that when using a new die punch some oil will be present
around the punched holes on the sheet. After punching 25 to 50 sheets
the die will no longer leave oil on the sheets. It is recommended that a
short test job be run after installing a new die or a die that has recently
been oiled to remove the residual oil.
B.
The Punch Chip Container for your SmartPunch Plus is located at the
front of the machine's base. The drawer should periodically be pulled out
and emptied. The SmartPunch Plus uses a sensor to determine when
the punch container is full. Once the punch container becomes full the
LCD display shows "Chip Tray Full" message.
SmartPunch Plus
Interchanging Die Sets:
WARNING: POSSIBLE PINCH POINT HAZARD. WHEN
INSTALLING DIE SETS IN YOUR SMARTPUNCH PLUS,
ALWAYS KEEP FINGERS AND OTHER BODY PARTS OUT
OF THE MACHINE'S DIE SET SLOT AND AWAY FROM ALL
AREAS OF THE DIE SET. FAILURE TO FOLLOW THESE
PRECAUTIONS MAY RESULT IN INJURY.
Step 8: Close the Access Door Panel.
Step 9: Proceed with your job.
Punch Chip Container:
GB
6