GBC SmartPunch Plus Manual De Instrucciones De Operación página 14

Crease & Performation dies
Perforation Die Backing Plate Exchange
It is recommended to exchange the backing plate of the 75-120gsm die
every 375K cycles and the 120-300gsm die every 250K cycles. Two
backing plates are provided with each Perforation die. Additional backing
plate kits can be purchased as service parts.
To exchange the backing plate:
1. Complete steps 1-4 from Section 4-A of this manual to remove
the die from the machine. Take care not to damage the chip
located at the rear underside of the die.
2. Unscrew the 2 knurled screws from the input sheet guide and
remove the input sheet guide.
3. Turn the die onto its side and unscrew the 3 knurled screws
from the underside of the die.
4. Remove the backing plate from the throat of the die. If the
backing plate does not come out easily, push it out from the
bottom by inserting a tool such as an Allen wrench, into the
holes provided, to release it.
5. Slide the new backing plate into the throat of the die and let it
fall into the backing plate opening.
6. Carefully turn the die over and secure the new backing plate
using the 3 knurled screws.
7. Re-attached the input sheet guide and secure the input sheet
guide using the 2 knurled screws.
Crease & Perforation Die Cleaning
Media being creased or perforated may become smeared by toner
deposits accumulating in the groove of the crease die or the backing
plate of the perforation die. If this is observed follow the procedure below
to clean the die.
To clean the die:
1. Complete steps 1-4 from Section 4-A of this manual to remove
the die from the machine. Take care not to damage the chip
located at the rear underside of the die.
SmartPunch Plus
2. Scrape toner residue [3] from the crease die groove [2] or
perforation backing plate using a plastic pointed swab [1] or
similar.
Be careful not to damage the groove of the crease die or
backing plate of the perforation die. Do not use a metal
pointed tip to remove the toner.
3. Clean excess toner particles [3] from the crease die groove [2]
or perforation backing plate using a foam or cotton swab [1].
4. Complete steps 6-9 from Section 4-A of this manual to insert
the crease to perforation die into the machine.
5. Once the die has been inserted, feed some sheets to confirm
that there is no toner marking on the sheet. If toner marking is
still observed complete the cleaning procedure again.
GB
15