Technical Specifications; Power Supply - FONESTAR MSH-110 Manual De Instrucciones

EN
INSTRUCTIONS FOR USE
1.- Connect the receiver to 12 V DC with the adapter provided with the system.
2.- Place the extending antenna (or antennas, depending on the model) in a vertical position and extend it
to its full length for the best reception.
3.- The receiver AUDIO OUTPUT can be connected to an amplifier, mixer, etc., through a balanced or
unbalanced line.
a- Balanced output through XLR connector: connect the AUDIO OUTPUT BALANCED MICRO to a
microphone input on your amplifier, mixer, etc.
b- Unbalanced output through 6.3 mm jack: connect the AUDIO OUTPUT AUX to a line input on your
amplifier, mixer, etc. The unbalanced output is of an adjustable level using the AUX VOLUME
control.
4.- Switch the receiver on with the POWER switch. The LED POWER indicator located on the front panel will
light up.
5.- Switch the microphone on (or microphones, depending on the model), the LED MIC ON indicator on the
receiver will light up.
6.- The LED AF indicator will flash if the signal is being received correctly.
7.- Frequency: the transmission frequency is fixed and is shown on the rear panel of the receiver.
NOTES: the receiver and the microphone/transmitter are adjusted to the same transmission frequency by
default. The transmission frequency cannot be changed by the user.
2 microphones of the same frequency cannot be used simultaneously. If 2 or more wireless
systems are used simultaneously, make sure that all of them operate on different frequencies.
Otherwise there could be interference problems among them.

TECHNICAL SPECIFICATIONS

CHARACTERISTICS Compact VHF receiver 174 to 194 MHz.
RECEIVER/MIC.
RESPONSE
OUTPUTS

POWER SUPPLY

DIMENSIONS
ACCESSORIES
MSH-110
Fixed to quartz frequency control.
Volume and squelch controls.
Balanced and unbalanced output.
Wireless hand-held microphone with
high quality unidirectional dynamic
capsule.
Audio: 1 balanced mic., XLR 600 Ω 20 mV
1 unbalanced line, 6.3 mm mono jack 10,000 Ω 100 mV
Receiver: 12 V DC with adapter included
Transmitters: 1 LR6-AA battery
MSH-135
Compact VHF receiver 174 to 194 MHz.
Fixed to quartz frequency control.
Volume and squelch controls.
Balanced and unbalanced output.
Tie-clip microphone and headset with
unidirectional electret condenser
capsule and wireless belt-pack
transmitter.
Fixed frequency channel
11 channels available
50-15,000 Hz
Transmitters: 2 LR03-AAA batteries
Receiver: 220 x 40 x 114 mm depth
6.3 mm mono jack cable
- 4 -