Power Switch - FONESTAR MSH-110 Manual De Instrucciones

HAND-HELD MICROPHONE
1.- Battery compartment: unscrew the cover to access the compartment. Insert a LR-6AA type battery,
preferably alkaline. When inserting the battery, make sure the polarity is correct.
2.- Power switch: it has 3 positions: ON, STAND BY (central position) and OFF. Move it to the ON
position to operate the microphone. Place the switch in the STAND BY position to save battery and the
microphone will turn on automatically when moved to the ON position. Before switching the
microphone on or off, make sure that the amplifier and receiver volumes are at their minimum in order
to avoid damaging the speakers with excessive volume peaks.
3.- Low battery indicator: when moving the switch to the ON or STAND BY positions, the red LED
indicator will light up and immediately afterwards will turn off. If the battery is low, the light will remain
lit in red. In this case, replace the battery with a new one.
BELT-PACK MICROPHONE
1.- BAT. LO: low battery indicator. When the switch is moved to the ON position or the central STANDBY
position, the red LED indicator will light up and then switch off immediately afterwards. When the battery
charge is low, the LED indicator will remain lit in red. In this case, replace the battery with a new one.
2.- VOL: the wireless belt-pack transmitter volume control.
3.- POWER SWITCH: it has 3 positions, ON, STAND BY (central position) and OFF. Place it in position ON
to operate. Move the switch to the STAND BY position to save battery and the microphone will switch on
immediately when moved to ON. Before switching the microphone on or off, make sure the amplifier and
receiver volume is set at its minimum to avoid damaging the speakers due to excessive peaks in volume.
4.- SENS: microphone sensitivity switch. It has 3 positions:
1. Place it in this position for condenser microphones.
2. Place it in this position for dynamic microphones.
3. Place it in this position to connect electronic instruments, guitars, organs, etc.
5.- MIC IN: microphone input, 3.5 mm stereo jack connector.
6.- Battery compartment: use two LR03-AAA type batteries, preferably alkaline. When inserting batteries,
make sure the polarity is correct.
(mod. MSH-110)
(mod. MSH-135)
- 3 -
EN