Kohler Anthem K-26341-NA Instrucciones

Record your model number:
Noter le numéro de modèle:
1413578-2
Anote su número de modelo:
WARNING: Risk of scalding. High water temperature can cause severe
burns. Set the valve water temperature at or below 120°F (49°C). Refer
to the temperature adjustment instructions for the valve.
Follow all local plumbing and building codes.
1A. Backer Board
1B. Sealant Tape
2A. Maximum distance to the finished wall surface.
2B. Minimum distance to the finished wall surface.
3A. Install a backer board between the studs.
5A. Connect the water supplies.
6A. To invert the hot and cold supply lines, swap the cartridges.
7A. Connect piping for the shower fittings only to the top or bottom port.
9A. Check all connections for leaks.
10A. Complete the finished wall.
Need help? Contact our Customer Care Center.
• USA/Canada: 1-800-4KOHLER (1-800-456-4537), Mexico: 001-800-456-4537
• For service parts information, visit kohler.com/serviceparts.
• For care and cleaning information, visit kohler.com/clean.
This product is covered under the KOHLER ® Faucet Lifetime Limited
Warranty, found at kohler.com/warranty. For a hardcopy of warranty terms,
contact the Customer Care Center.
AVERTISSEMENT : Risque d'ébouillantage. Une température d'eau
élevée peut causer des brûlures graves. Régler la température de l'eau
de la vanne à 120°F (49°C) ou moins. Consulter les instructions de réglage de
température pour la vanne.
Respecter tous les codes de plomberie et de bâtiment locaux.
1A. Planche d'appui
1B. Ruban d'étanchéité
2A. Distance maximum jusqu'à la surface du mur fini.
2B. Distance minimum jusqu'à la surface du mur fini.
3A. Installer une planche d'appui entre les montants.
1413578-2 A
-
1
A B
4
1
2
A
B
5
A
3
A
6
A
Kohler Co.