Evolution R150RCP-Li Instrucciones Originales página 10

ASSEMBLY
To install the battery (Fig.1)
Slide the battery into the base of the tool until it clicks into place.
To remove the battery
Press the battery release button and slide the battery from the base
of the tool.
WARNING: Use only recommended lithium ion batteries.
Installing/removing blade
Note: We recommend that the operator wears protective gloves when
handling blades. Care should be exercised as a recently used blade
could be hot and/or contaminated with debris.
Note: Please remove battery from the machine before carrying out
the following installations.
To install a blade:
• Ensure that the blade holder is clean and free from debris or other
contaminates.
• Twist and hold the blade clamping dial anti-clockwise.
(Fig. 2)
• Fully insert the shank of the blade into the blade holder.
• Release the blade clamp so it returns to its original position.
• Check that the blade is secure.
WARNING: It is important that the hole in the tang of the blade
engages with the 'spigot' located inside the blade holder.
To remove a blade:
• If recently used allow the blade to cool down.
• Ensure that the machine is facing downwards to allow
any debris to fall out.
• Twist and hold the blade clamping dial anti-clockwise.
• Gently pull the blade from the blade holder.
Adjusting the contact plate (Fig.3)
Note: The workpiece contact plate is pivoted and adjustable. This
feature allows the contact plate to adjust and lie flush on a workpiece
surface even when the machines main body is at a slight angle to that
surface.
The contact plate should always rest on the material when sawing to
avoid excessive vibrations.
1) Loosen the 2 screw grubs under the front handle. (Fig.4)
2) Adjust the contact plate position as necessary.
3) Tighten the 2 grub screws.
www.evolutionpowertools.com
Fig. 1
Fig. 2
Fig. 3
Fig. 4
10