Troubleshooting - Blumfeldt Heatwave Manual Del Usuario

EN
32

TROUBLESHOOTING

Problem
The pilot flame cannot
be ignited.
The pilot light does not
stay on.
The burner does not
ignite.
Potential cause
The gas cylinder valve
is closed.
Blockage in the burner
nozzle or line
Air in the gas line
Low gas pressure
The igniter does not
work.
Dirt accumulation
around the pilot flame.
The connection
between the gas valve
and the flame assembly
is loose.
Faulty thermocouple
Low gas pressure
Blockage in the burner
opening.
The control dial is in the
"OFF" position.
Solution
Open the gas cylinder
valve.
Clean the burner
nozzle or pipe or have it
replaced.
Turn off the gas bottle
and press the control
dial down for 1-2
minutes or until you
smell gas.
Gas bottle is only
slightly full or empty.
Light the pilot light
with a match. Have the
igniter replaced.
Remove the
accumulation of dirt.
Tighten the connection
and carry out a leak
test.
Replace the
thermocouple.
Replace the gas bottle.
Remove the blockage.
Ignite the burner
by turning the
control dial to the
"IGNITION&LOW"
position (see section
"Operation")