Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Caution! Do not use a dosing device/ball when
carrying out a washing and drying programme.
1.
Load the laundry and add detergent and fabric soft-
ener.
2.
Switch the machine on by turning the selector dial to
the set washing programme/fabric.
3.
Select the required options by pressing the relevant
buttons.
If possible, do not select a spin speed lower than
that proposed by the appliance to avoid too long a
drying time therefore saving energy.
In any case the reduction of the spin speed is only
possible after selecting drying.
The lowest values you can select are 900 r.p.m. for
cottons and synthetics and 700 r.p.m. for delicate
fabrics.
Fluff in the fabrics
During the WASHING AND/OR DRYING PHASE, certain
types of fabric, such as sponge, wool, sweatshirt, could
release fluff.
The released fluff could stick to the fabrics during the next
cycle.
This drawback increases with technical fabrics.
To prevent the fluff in your clothes, it is recommended:
• To do not wash dark fabrics after you washed and dried
light colored fabrics (new sponge, wool, sweatshirt es-
pecially) and vice versa.
• To air-dry this type of fabrics when they are washed the
first time.
Care and cleaning
Warning! You must DISCONNECT the appliance
from the electricity supply, before you can carry out
any cleaning or maintenance work.
Descaling
The water we use normally contains lime. It is a good idea
to periodically use a water softening powder in the ma-
chine. Do this separately from any laundry washing, and
according to the softening powder manufacturer's instruc-
tions. This will help to prevent the formation of lime de-
posits.
www.zanussi.com
All manuals and user guides at all-guides.com
4.
Set the drying time by pressing button 4. The display
shows the whole duration of the washing and the set
drying cycle.
If you set a washing programme and only 10 mi-
nutes of drying cycle, the total duration displayed
includes also the unrolling and the cooling phase.
5.
Start the programme by pressing button 7. The time
remaining is updated every minute on the display.
6.
At the end of the programme turn the selector dial to
the
position to switch the machine off and re-
move the laundry.
• To clean the drain filter.
• After the drying phase, thoroughly clean the empty
drum, the gasket and the door with a wet rag.
To remove the fluff inside the drum, run a special pro-
gramme to clean it:
• Empty the drum and clean the drum, the gasket and the
door with a wet rag.
• Turn the programme selector to the rinse programme.
• Activate the cleaning function by pressing at the same
time button 5 and button 8 until the display shows
CLE.
• Press button 7 to start the programme.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser drawer
should be cleaned regularly.
17
Capítulos
Tabla de contenido
