Zolia Barking Stop Plus Manual página 4

○ 1. Microphone sensor
○ 2. Charging port (with cover)
○ 3. Conductive Silicone Cover
○ 4. Intensity level Display
○ 5. Power Button
○ 6. Beep + vibration mode
○ 7. Mode selection and level intensity settings
○ 8. Beep + Vibration + Static Stimulation mode
○ 9. Battery level
● How to use this Bark Collar
○ Charging instructions
*Please charge the collar before use.
This product is provided with a charging cable (DC interface, 5V output voltage). Attention : Please
use only the original cable to charge this collar. If you use others, be sure that the output voltage is
5V, otherwise it may damage the collar device.
If Low Battery : Battery indicator shows red and one bar only (Left picture). The battery indicator will
scroll during charging and it will become solid green with 4 bars when fully charged (Right picture).
○ Turn on / Turn off
Turn on : Press the Power Button one time to turn on the collar, then you will hear two beeps and a
green light will lit on.
Turn off : Press and hold the Power Button 1.5 sec,you will hear one beep and collar will be turned off.
Note : Collar will enter Standby mode after 1 minute of inactivity.
○ Two different function mode switching :
This bark stopper has two different function modes: With static stimulation function and without static
stimulation function. You can switch mode by pressing the M button.
- With static stimulation function: with beep, vibration and static stimulation
function,and the corresponding red stimulation icon is displayed as shown in the
picture below :
- Without static stimulation function: with beep and vibration function only. The
corresponding green vibration icon is displayed as shown in the following picture :
4