Zolia Barking Stop Plus Manual página 5

○
Cycle and fixed mode switching
This bark stopper also has two different anti bark modes :cycle and fixed.
Default mode is cycle mode. Default intensity collar is programmed to increase intensity after each
bark (Cycle mode). If you want to choose and maintain the same intensity after each bark (fixed
mode), you have to press and hold the "M" button. Then the collar switches to fixed mode. If you
press the power button three times continuously and quickly, then the collar will switch to cycle mode.
(LCD Display will show number 0)
We recommend that you start without static stimulation function mode to let your dog adapt to the
beep/vibration function first and avoid excessive reactions. If your dog shows no reaction for
beep/vibration, then start at level 1 static stimulation. Please always start at the lowest level.
Intensity levels go from 1 (lower) to 6 (higher). Under cycle mode, first triggering is level 1 warning, If
the dog continues to bark, then level 2 warning is activated, then level 3... , until reaching the level 6
warning.
Under both modes (cycle or fixed), when the collar is triggered, it will display and flash in the LCD
display the current corresponding level. For example, under level 6, it will display the number 6 by
flashing 3 secs until the bark stops. Then the flashing will stop too.
Under both modes, after the 6th triggering, Collar will enter in 'Protection Mode'. This means that the
collar will stop working for 1 minute. (Number 0 will be flashed)
○ Testing light instructions
A. Press the power button to turn on
B. Hold the Test Light Contacts to the contact Points.
C.Activate the Static Stimulation function mode.
D. Please send a similar sound of "Woof, Woof " to the microphone (imitating dog barking). Since the
frequency of human voice is different from that of dogs, please test more time.
● Wearing method
Important note: The correct wearing and positioning of the bark stop collar is important for its
effective operation. To ensure proper wearing, please follow these steps :
○ Make sure the bark stop collar is closed
○ Keep your dog in a comfortable standing position. (As shown below in A picture)
○ Place the bark stop collar on the dog's neck, then place the bark stop collar control ring in the
center, and the "on/off" switch on the operating surface of the collar, facing upward.(As shown
below in picture B)
○ Check the tightness of the bark stop collar by inserting a finger between the dog's collar and
the back neck. The proper position should be comfortable rather than tightened.(As shown in
picture C)
5