BE Power Equipment P1715EN Manual Del Operador página 12

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Operation Tips
• Test the GFCI (For US unit only) before each
Note:
use:
1. Plug GFCI into power outlet. Indicator should
turn green to show that cord has power.
2. Press test button, green indicator should turn
off to verify that GFCI cut off power to the cord.
3. Press reset button – green indicator should
turn on to show that cord has power again.
4. When GFCI is working properly, green
indicator will turn on when power is applied.
If green indicator turns off, it has detected
electric leakage and the GFCI cut off power to
theappliance.
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal. The
pump is priming itself so it is ready to operate
when the trigger is squeezed. Turn off the power
washer if not being used after five minutes.
• The o-rings on the bayonet end of the nozzle
lance should be cleaned regularly and lubricated
with non-water soluble grease such as petroleum
jelly.
• Keep the nozzle cleaning wire for use in
unclogging the nozzle. If you lose the cleaning
wire, a straightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs
because the impact force of the water pressure
exceeds the durability of the surface. Bare wood
can be penetrated; paint can be peeled off, etc.
You can vary the force of your power washer by
controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface
being cleaned.
• NEVER use a narrow high pressure stream of
water on soft surfaces susceptible to damage.
12
Adjusting Soap Levels on Foam Cannon
Twist knob to adjust the level of soap as indicated
on the top of the Foam Cannon (H). Twist toward the
higher concentration of bubbles for more soap, or the
opposite direction for less.
bepowerequipment.com
F
H