Levenhuk Discovery Report WA50 Guia Del Usuario página 4

Discovery Report WA50 Weather Station
EN
The kit includes: base station, sensor, user manual, and warranty.
Also required (not included): 2 AAA batteries for the sensor; 4 AA batteries for the base station.
Getting started
Base station
• Open the battery compartment cover (17) and insert 4 batteries according to the correct polarity. Close the
cover. Wait until the indoor temperature is displayed on the base station.
• To reset the base station, press RESET.
Sensor
• Open the battery compartment cover (4). Insert 2 batteries according to the correct polarity. Close the cover.
Sensor connection
• Place the base station and the remote sensor within the effective transmission range.
• If the reception is successful, the display will show the temperature and humidity of the outdoor sensor. If the
values are not received from a channel, check the batteries and try it again. Check if there is any source
of interference.
• When changing batteries, replace the batteries first in the base unit, and then in the sensor, to re-establish the
connection. If you change the batteries only in one of the devices (for example, in the sensor), the signal may
not be received correctly.
• The default channel is channel 1.To change it, press and hold the CHANNEL button on the base station, and
then press the button again to choose between channels 1, 2, and 3.
• The effective range may differ depending on the unit's position. Due to interference (various remote control
devices, etc.), the maximum distance between the base unit and the sensor may be significantly reduced. In
such cases, we suggest moving the base unit and sensor a little. Sometimes it is enough to move one of these
units a few inches!
NOTE! Although the sensor is weather resistant, never place it in direct sunlight or in the rain or snow.
Time setting
Press the SET button and hold it for 3 seconds. The digits that are to be set are flashing. Press ▲/ZONE or ▼
to change the value, and then press SET to continue. The setting order: 12/24hr > Hour > Minute > Year > Month >
Date > DST ON/OFF. Finally, press the SET button to save the settings and exit.
Time zone setting
Press ▲/ZONE to change the time zone. The digits that are to be set are flashing. Press ▲/ZONE or ▼ to change
the value. Display order: MST > PST > AKT > HST > EST.
Alarm setting
Press the ALARM button. To turn the alarm on or off, press ▲/ZONE.
•
To set the alarm, hold the ALARM button. The digits that are to be set are flashing. Press ▲/ZONE or ▼
•
to change the value. The setting order: Hour > Minute. Finally, press the ALARM button to save the settings
and exit.
• When the alarm sounds, press SET to activate the snooze function. The alarm will sound again in 5 minutes.
Press any key to exit.
Temperature units setting
Press the ▼ button to switch between °C and °F.
Specifications
Base station
Air humidity, units of measurement
Operating humidity range
Temperature, units of measurement
Operating temperature range (indoors)
Screen
% (RH)
25... 99%
°F, °C
–0... +50°C (+32... +122°F)
monochrome
4