Evolution R90 JGS Li Instrucciones Originales página 9

www.evolutionpowertools.com
Fig. 1
Fig. 2
Fig. 3
Fig. 4
ASSEMBLY
To install the battery (Fig.1)
Slide the battery into the base of the tool until it clicks into place.
To remove the battery
Press the battery release button and slide the battery from the base.
Installing the parallel edge guide (Fig.2)
Unscrew the parallel edge guide clamping screw (4) and insert
the parallel edge guide into the base plate. Replace the screw and
tighten.
Installing the blade (Fig.3)
1. With the blade facing forward, retract the blade clamp to the open
position.
2. Firmly install the saw blade into the blade clamp and release the
clamp.
Removing the blade
To remove the blade, retract the blade clamp to open position.
Remove the blade and release the clamp.
Installing Dust port (Fig.4)
To attach the port to the tool, insert into the rear of the base plate.
Variable speed trigger
To start the tool, depress the lock-off button (2) and press the variable
speed trigger (1)
9
EN