Care Recommendations; Interior Cleaning; Condenser Cleaning - Sub-Zero Designer Serie Manual De Instrucciones

Care Recommendations

Cleaning
STAINLESS STEEL EXTERIOR
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly
wipe the surface with a water-dampened microfiber cloth
followed by a dry polishing chamois. Always follow the
grain of stainless steel.

INTERIOR CLEANING

To clean interior surfaces and all removable parts, wash
with a mild solution of soap, water, and baking soda. Rinse
and dry thoroughly. Avoid getting water on the lights and
control panel.
CAUTION
Do not use vinegar, rubbing alcohol, or other
alcohol-based cleaners on any interior surface.
VACATIONS
For extended vacations, turn power off at the control
panel. Empty the unit and block doors open slightly to let
fresh air in and keep the interior dry. The water filter should
be replaced before start-up.
22 | Sub-Zero Customer Care 800.222.7820

CONDENSER CLEANING

CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
The condenser is located behind the kickplate. Clean the
condenser every 6–12 months.
To clean the condenser:
Turn power off at the control panel.
1
2 Remove the kickplate by extracting the two mounting
screws. Refer to the illustration below.
3 Use a soft bristle brush and vacuum to remove dust and
lint from the condenser.
CAUTION
Failure to clean the condenser could result in tem-
perature loss, mechanical failure, or damage.
CONDENSER
SCREW
Condenser location