Care Recommendations; C O N D En Ser C Lean I N G; Condenser (Behind Grille) - Sub-Zero PRO 48 Guía De Uso Y Cuidado

C A R E RE C O MM E NDAT I O N S
Cleaning
IN T E R I O R C LE A N I NG
To clean interior surfaces and all removable parts, wash with
a mild solution of soap, water and baking soda. Rinse and
dry thoroughly. Avoid getting water on lights and control
panel.
CAUTION
Do not use vinegar, rubbing alcohol or other alcohol-
based cleaners on any interior surface.
STA INL E S S S T E E L E X T E RI O R
Use a nonabrasive stainless steel cleaner and apply with a
soft lint-free cloth. To bring out the natural luster, lightly wipe
surface with a water-dampened microfiber cloth followed by
a dry polishing chamois. Always follow the grain of stainless
steel.
|
10 Sub-Zero Customer Care 800.222.7820

C O N D EN SER C LEAN I N G

CAUTION
Before cleaning the condenser, turn power off at the
control panel. Wear gloves to avoid injury from sharp
condenser fins.
The condenser is located behind the grille. To access, pull
out on the bottom edge of the grille and rotate upward. Use
a soft bristle brush and vacuum to remove dust and lint
from the condenser. Clean the condenser every three to six
months. Refer to the illustration below.
IMPORTANT NOTE:
vacuum in the direction of the fins.
CAUTION
Failure to clean the condenser could result in tempera-
ture loss, mechanical failure or damage.
VAC ATIO N S
For extended vacations, turn power off at the control panel.
Empty the unit and block doors open slightly to let fresh
air in and keep interior dry. Water filter should be replaced
before start up.
GRILLE
SCREW
LOW-VOLTAGE
CABLES
Condenser location.
To avoid damaging condenser fins,
CONDENSER