Transportation Locks - Mettler Toledo LV12 Manual De Referencia

4.4 Assembling the accessory
1 Remove the four transportation locks (1) (one in each
corner).
2 Put the feeder plate (2) on the accessory and fix it by
turning it clockwise along the slotted holes.
3 Put the cover (3) on the accessory. Take the marks on
the top of cover as reference for the correct orientation
(the marks have to point to the front as indicated in the
image). Push the cover down until it snaps into place.
4 Fit the chute (4) to the two clamping blots at the lateral
opening and push it in as far as it will go.
5 Connect the accessory to the balance using the delivered
cables (either by USB or RS232 according to the used
balance).
6 Set up the accessory as described in [Connecting the
accessory Page 13].
12 Installation and Putting into Operation​ ​
1
2
3
4
Automatic Feeder