YATO YT-82854 Instrucciones Originales página 9

PRODUCT CHARACTERISTICS
A battery glue gun is designed for bonding diff erent materials by means of hot-melt glue cartridges. Thanks to effi cient battery of high capacity it is possible
to work with the product wherever it is not possible to work with guns with external power supply. The product has not been designed for commercial appli-
cations. Correct, reliable and safe operation of the product depends on proper operation, therefore:
Before starting the work with this product, please read this manual and keep it properly.
The supplier does not assume any liability for any damages resulting from misuse of the tool, failure to follow safety regulations and recommendations spec-
ifi ed in this manual. Misuse of the tool will also result in loss of guarantee and warranty rights of the user.
PRODUCT ACCESSORIES
The product is supplied in a complete state and requires no assembly. Together with the product there are provided: the rechargeable battery and charging
station (charger).
TECHNICAL DATA
Parameter
Catalogue number
Operating voltage
Protection class
Insulation class
Glue cartridge diameter
Operating temperature
Heating time
Max. operating time
Capacity
Weight
Battery type
Battery capacity
Charger
Input voltage:
Mains frequency
Rated power
Input current:
Output voltage:
Output current:
Charging time
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The notion of electric tool used
in the instructions applies to all the tools which are powered with electric current, both wire tools and wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours. Electric tools generate
sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters whatsoever in order to adapt the
plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and disconnect the plug from
GB
Measuring unit
[V d.c.]
[mm]
[ O
[s]
[min]
[g/min]
[kg]
[Ah]
[V~]
[Hz]
[W]
[A]
[V d.c.]
[A]
[h]
O R I G I N A L I N S T R U C T I O N S
C]
Value
YT-82854
18
IPX0
III
11,2
200
25
60
25
0,3
Li-Ion
2
220 - 240
50 / 60
50
0,8
21,4
2,4
~1
9