Tabla de contenido
Idiomas disponibles
Idiomas disponibles
B
OUTSIDE BACK EXHAUST
Duct)
INSTALLATION OVERVIEW
B2. Remove Blower Plate
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
plate are securely tightened when they are reinstalled.
This will help to prevent excessive vibration.
and secured, and that the wires are not pinched.
3/8" TO EDGE
Trim the rear wall template
12"
NOTE: IT IS VERY IMPORTANT
TO
READ AND FOLLOW
THE DIRECTIONS
IN THE INSTALLATION
INSTRUCTIONS
WITH THIS
BEFORE PROCEEDING
REAR WALL TEMPLATE.
4"
This Rear Wall Template
serves to position the bottom
mounting plate and to locate
the horizontal exhaust
outlet.
1. Use a level to check
that the template is positioned
2. Locate and mark at least
accurately.
one stud on the left or
right side of the centerline.
It is important to use at
least one wood
a stud to support the weight
screw mounted firmly in
two additional, evenly spaced
of the microwave. Mark
toggle bolts.
locations for the supplied
locations. Where there is
3. Drill holes in the marked
for wood screws. For holes
a stud, drill a 3/16" hole
stud, drill 5/8" holes for
that do not line up with a
toggle bolts.
MOUNTING PLATE
DO NOT INSTALL THE
AT THIS TIME.
4. Remove the template
Instruction book for your
from the rear wall.
5. Review the Installation
installation situation.
para consultar la
Darle vuelta a la hoja
versión en Español.
24"
Locate and mark holes
to align with holes in the
mounting plate.
IMPORTANT:
STUD ON EITHER SIDE
OF
LOCATE AT LEAST ONE
THE CENTERLINE.
EVENLY
MARK THE LOCATION
FOR 2 ADDITIONAL,
SPACED TOGGLE BOLTS
IN THE MOUNTING PLATE
AREA.
Locate and mark holes
to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE
THE CENTERLINE.
MARK THE LOCATION
along the dotted line.
SPACED TOGGLE BOLTS
Trim the rear wall template
AREA.
B1. PREPARING THE REAR WALL FOR OUTSID
BACK EXHAUST
You need to cut an opening in the rear wall for outside
exhaust.
15
(Horizontal
along the dotted line.
STUD ON EITHER SIDE
OF
EVENLY
FOR 2 ADDITIONAL,
IN THE MOUNTING PLATE
B2. REMOVE BLOWER PLATE
Remove and save the screw that holds the blower plate to
the microwave. Lift off the blower plate.
Blower Plate
B3. ATTACH THE MOUNTING PLATE TO THE
WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a wall
stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach the
toggle wings to
3
4
To use toggle bolts:
E
Mounting
Plate
3. Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount the
plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the bottom of the mounting plate touch the
and that the plate is properly centered under the cabinet.
CAUTION:
the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
Back of
Microwave
Spacing for Toggles
Thickness
Toggle
Bolt
Bolt End
EN
Tabla de contenido
