Remedy In Case Of Faults; Servicing; Specifications - Titan CS105 Manual De Propietario

remedy in case of faults

5
reMedy in caSe of faultS
type of malfunction
A. Restricted air flow or no air flow
B. Filter warning light is on
C. The turbine has no power
D. Excessive arcing/sparking in the
turbine
The turbine motor can be damaged if not serviced properly. Have the brushes (P/N 0276878) checked for wear by an
i
authorized service center every 400 hours.
Clean filters regularly. Clogged filters can cause excessive heat and possibly damage the unit.
For additional troubleshooting information, see the manual that came with your gun.
5.1
Service
Should your spray system need service during the warranty period, return your unit and the proof of purchase to the distributor
where it was purchased. At our option, the unit will be repaired or replaced. In a continued commitment to improve quality, we
reserve the right to make component or design changes when necessary.
5.2

SpecificationS

Voltage
Power consumption P1
Max. current comsumption
Max. air ram pressure
Rpm
Turbine weight
Mains cable
Container capacity
Air hose
Whip hose length
Nozzle set (standard)
8
possible cause
1. Air flow adjustment knob on the spray
gun is turned off
2. Air filters are clogged
1. Air filters are clogged
1. No power at the power supply
2. Circuit breaker has been tripped.
3. Worn turbine brushes
1. Worn turbine brushes
2. Damaged commutator
230 V~, 50/60 Hz
1836 W
9,0A
0,72 bar (10,5 psi)
21 000 rpm
15 kg
3 m
1 liter
9,1 m
1,5 m
No. 4 (1.8 mm)
Measures for eliminating the malfunction
1. Adjust the air flow adjustment knob
2. Clean or replace the filters
1. Clean or replace the filters
1. Check the power supply
2. Reset the breaker. If problem persists, have turbine
inspected at an authorized Titan service center.
3. Have the brushes replaced at an authorized Titan service
center
1. Have the brushes replaced at an authorized Titan service
center
2. Replace the turbine (contact a Titan service technician)
Max. permissible coating
temperature
Typical coating flow rate
Max. noise level
turbine
paint spray gun
* Measuring location: 1 m in distance from the unit 1.60 m
above the floor, reverberant floor.
** Measuring location: 2.5 m distance from the unit 1.60 m
above the floor.
CS105
43ºC
0,35 l/min
75 dB (A) *
76 dB (A)